Connect an Arduino UNO + WIZnet WizFi250 to Ubidots over HTTP

Original : https://help.ubidots.com/en/articles/513313-connect-an-arduino-uno-wiznet-wizfi250-to-ubidots-over-http

The Wifi shield（Fi250）is a economic internet connectivity solution that is easily enabled using Arduino software. The Wi-Fi module supports IEEE 802.11b/g/n mode with a maximum speed up to 65Mbit/s. The Wifi shield (Fi250) combines with an on-board antenna making it easy to build your project in a small, protective case.

The module comes with a computer interface software which allows you to control and upgrade the module via USB-UART converters.

Following this guide you will be able to POST data to Ubidots using the WIZnet WizFi250 shield connected to an Arduino UNO Board in just a couple of minutes!

Step-by-Step

1. Hardware Setup

2. Setting up the Arduino IDE

3. Sending (POST) Data to Ubidots

4. Summary