details
Features
- A new all hardware TCP/IP protocol stack network chip since W5100, W5200 and W5300. With lower power consumption and operating temperature and modified process, and it’s the best solution choice of the embedded Ethernet;
- Adopts U-shape 27pin Microduino standard interface, and can be used stacked with module Microduino-RJ45 . Plug and play. The whole size is smaller;
- Open-source hardware circuit design, and compatible-with-Arduino compilation development environment;
- With unified Microduino interface specification and abundant periphery modules, which make it can be extended and connected with other modules and sensors which meet the Microduino interface specification, quickly, conveniently and flexibly;
- With 2.54-spacing female header connector interface, which is convenient for the integration to the pegboard.+
Specification
- Communication protocol
- Supports hardware TCP/IP protocol：TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
- Supports 8 separate ports（Socket）to communicate at the same time.
- With built-in 10BaseT/100BaseTX Ethernet Phy.
- Supports automatic negotiation（10/100-Based full duplex/half duplex）.
- Operating characteristic
- Supports power down mode.
- Supports wake-on-lan.
- Supports automatic reply（full duplex/half duplex）
- Update rate
- Supports high speed serial peripheral interfaces.
- With 32k bytes interior send and receive buffer.
- Interface features
- TTL level input
- Single power supply: 3.3V;
- Doesn’t support IP burst.
Status indicator
- Two programmable LED outputs used to show the status of connection, sending, receiving, conflict, full duplex and half duplex;
COMMENTS