
details
Description
The mt011 is an RC2014 compaitible ethernet controller based on the w5500 wiznet chip with a Featherwing breakout board.
This board was developed by Mark T with input from Jay Cotton.
Building
make NIC=w5500 HBA=mt011
Using
To run this board with CP/NET there are a few things that are needed. A ROM/RAM board with RomWBW v3.0.1 or newer. The MT011 board.
The MT011 does not reset the W5500 during system RESET, so it retains settings during system RESET-reboot. The W5500 may be reset by software, when required.
##On your CP/M console: ###CP/M 2.2
b:pip a:=c:ccp.spr (assumes your cpnet code is installed on the c drive)
c:ifconfig -s (https://github.com/jayacotton/inettools-z80) (this command gets a DHCP address for the wiznet board)
c:wizcfg 0 0 <host ip address> 31100 45
c:cpnetldr (this loads the cpnet bios code )
c:network k:=c:[0] (k on my machine, YMMV)
###CP/M 3.0
c:ifconfig
c:wizcfg 0 0 <host ip address> 31100 45
c:network k:=c:[0]
##Caveat’s
The above assumes you have a server running on a host machine somewhere. See cpnet-z80/doc/CpnetSocketServer.pdf for information on running the server.
COMMENTS